The AV receiver will enter standby mode automatically in 3 minutes regardless of whether 8ON/STANDBY is pressed. Do not use 8RECEIVER on the remote controller. The message “Completed!” appears on the AV receiver’s display, indicating that the update has been completed. Do not turn off the AV receiver and do not remove the USB device during the update process. The on-screen display will reappear after the update is complete, and upon turning the AV receiver off and on again. When this occurs, you can still view the update progress on the AV receiver’s display. During the update process, the on-screen display may disappear depending on the updated program. Note that this option will not be available if there is no firmware file newer than the currently installed version. Select “Update via USB” and press ENTER. Select “Firmware Update” and press ENTER. Press RECEIVER followed by HOME on the remote controller. It takes 20 to 30 seconds to recognize the USB device. “Now Initializing.” appears on the AV receiver’s display and then the name of the USB device is displayed. If the AV receiver is in standby mode, press 8ON/STANDBY on the AV receiver to light up the front display. Make sure the AV receiver and TV are turned on. When the AV receiver has two USB ports, you can use either one. Remove the USB device from your PC and connect it to the USB port on the AV receiver. Copy all the extracted folders including all folders and files to the USB device. The numbers of folders and files differ according to the model. If there is any data in the USB device, remove it first. Improve reception capability in certain TuneIn Radio stations
0 Comments
Leave a Reply. |